+ Reply to Thread
Results 1 to 3 of 3

Thread: Gerard Morin: "I hooked it all up and a tune came out of there. It's all RF..."

  1. Link to Post #1
    Avalon Member
    Join Date
    4th December 2014
    Posts
    1,442
    Thanks
    2,127
    Thanked 8,737 times in 1,354 posts

    Default Gerard Morin: "I hooked it all up and a tune came out of there. It's all RF..."

    Oh man, I'm blown away by this...


  2. The Following 18 Users Say Thank You to WhiteLove For This Post:

    A Voice from the Mountains (18th July 2015), Baby Steps (18th July 2015), ceetee9 (18th July 2015), Chip (18th July 2015), Cipher (18th July 2015), Dennis Leahy (18th July 2015), eagle0027 (18th July 2015), Fellow Aspirant (18th July 2015), Gardener (18th July 2015), Lefty Dave (18th July 2015), LifeAngel (19th July 2015), Lifebringer (18th July 2015), mpennery (18th July 2015), Noel (3rd August 2015), Richard S. (18th July 2015), sandy (18th July 2015), Sunny-side-up (18th July 2015), toppy (18th July 2015)

  3. Link to Post #2
    Canada Avalon Member Ernie Nemeth's Avatar
    Join Date
    25th January 2011
    Location
    Toronto
    Age
    61
    Posts
    3,525
    Thanks
    15,126
    Thanked 20,705 times in 3,292 posts

    Default Re: Gerard Morin: "I hooked it all up and a tune came out of there. It's all RF..."

    That music sounds like the William Tell overture...

    Love it when he says, "What, is it a million dollar cow?" in response to the outrageous cost of a little six ounce steak.

    I'm with him that the greed in this world has surpassed all reasonable limits. No one deserves 1000% profit for anything!

    I've played with these motors myself. They are a puzzle. I remember when I was studying for my electrician's exam, I compiled a list of fifty different motors and their characteristics. I also went deep into the motor/generator effect and the mathematics behind it. I knew way more about electrical equipment than any other electrician. That's why I am the king of troubleshooting!

    On the frequency side, electricians know nothing about frequency. This is because in the world there are really only two or three frequencies in extensive use - 60, 50, 24. Never been involved with the 24 Hz systems. I did some work in Timmins Ontario a decade ago, retrofitting the lighting in an ore processing plant. We changed out the ballasts in the lights with electronic ballasts pumping 240 volts at 50,000 Hz! Each ballast could power two lights so we were instructed to just run two single conductors free air to the second light with no protection (conduit or other means). I refused to do it because in my training this was unsafe. The boss was a good friend of mine and he had an electronics background. He took me aside and ran the math by me to explain why 240V @ 50,000Hz has virtually no current in it and is therefore safe. It took a while to get it through my head and bypass my extensive training and study - but he was right. At high frequency the current is in the milliamp range or less and is almost perfectly safe to handle.

    As a matter of fact, I would not believe his argument or the math until he finally just walked over and grabbed two ends of a live ballast and held the bare wires in his hand for about ten seconds without any deleterious effect. Strange...
    Forget about it

  4. The Following 12 Users Say Thank You to Ernie Nemeth For This Post:

    Chip (18th July 2015), Dennis Leahy (18th July 2015), Fellow Aspirant (19th July 2015), Flash (18th July 2015), Gardener (18th July 2015), Meggings (18th July 2015), mpennery (18th July 2015), Nasu (18th July 2015), sandy (18th July 2015), Sunny-side-up (18th July 2015), toppy (18th July 2015), WhiteLove (18th July 2015)

  5. Link to Post #3
    UK Avalon Member Sunny-side-up's Avatar
    Join Date
    4th April 2013
    Location
    Between here & there
    Age
    60
    Posts
    3,605
    Thanks
    38,950
    Thanked 16,251 times in 3,325 posts

    Default Re: Gerard Morin: "I hooked it all up and a tune came out of there. It's all RF..."

    Thank you WhiteLove for your post.

    What can I say: Bumping

    Quote Posted by WhiteLove (here)
    Oh man, I'm blown away by this...

    Thank you Gerard Morin, See the truth and talk about it, show it, transmit it
    I'm a simple easy going guy that is very upset/sad with the worlds hidden controllers!
    We need LEADERS who bat from the HEART!
    Rise up above them Dark evil doers, not within anger but with LOVE

  6. The Following 2 Users Say Thank You to Sunny-side-up For This Post:

    Gardener (18th July 2015), WhiteLove (18th July 2015)

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts